Was six months in a leaky boat banned in the UK?

When ‘Six months in a leaky boat’ was released in the UK (1982), it was banned by the BBC from airplay as the Royal Navy was involved in the Falklands War. The reference to ‘leaky boat’ was considered inappropriate timing and a criticism of the war.

What year was six months in a leaky boat released?

1982
Six Months in a Leaky Boat / Released

Was six months in a leaky boat banned in the UK? – Related Questions

How do you check for boat leaks?

How is water getting in my boat?

Bilge water is water that does not drain off the side of the deck or through the scupper, and is typically caused by rough seas, excess rain, or untreated leaks in the boat’s hull. It is also commonly caused by mast drip, window leaks, excess condensation, or hose pipes that have been compromised by rot and rust.

How do I know if my boat hull is leaking?

Is water in a boat bilge normal?

This is normal and should not be a cause for concern as long as the water does not keep entering the boat. As long as the bilge pump is not running often, the amount of water in the bilge should be safe.

How many miles can discharge bilge water?

In the United States and the Baltic and North Seas disposal of separated bilge water only permitted at least 12 nautical miles from shore.

How much water is OK in the bilge?

The bilge pump should draw down water to about 1/2″ depth or less, so if you’re ending up with that much water in the bilge you have two problems, the source of the water and the fact that the bilge pump is not kicking on. It’s easy to test the bilge pump.

Should I leave bilge pump on while boating?

Built-in manual bilge pumps must be turned on when you need to drain the bilge. You can usually find an on/off switch at the helm in motorized boats. If your boat is equipped with one of these, be sure to keep an eye on the water levels inside the boat and turn it on before you take off from the dock.

What happens when bilge is full?

Too much water entering the bilge too rapidly will cause the vessel to sink. But keeping the compartments well sealed also means little exchange of outside air with poor ventilation.

Should a boat bilge be dry?

To alert you to small water leaks

If you keep a dry bilge, it is much easier to see whenever you get a small leak somewhere in the boat. If you dry out the bilge on one day, then come to the boat the next day and see water, then you’ll know that water is coming into the boat somehow.

Why are boats always pumping out water?

Boats typically spit out water to keep the bilge free of water. Water builds up over time inside the bilge and the bilge pump automatically pumps the water out again. Often, when boats are spitting out water, it is because they are expelling water that has built up in the bilge of the ship.

How do you keep a bilge completely dry?

To keep the bilge dry, all you need to do is manage where the water goes from the stuffing box. Instead of dripping into the bilge, set a pan or other collector under the stuffing box to accumulate the water without getting the bilge wet.

Can a bilge pump run dry?

For one, they don’t need any priming. Diaphragm pumps can run completely dry, whereas centrifugal pumps will get damaged. Because of this, diaphragm pumps can remove all the water in the bilge.

What can I put in my boat to keep the moisture out?

Purchase a Dehumidifier for Your Boat

As a good rule of thumb, the relative humidity levels should be between 50% and 60% to reduce moisture-related problems. Mini dehumidifiers are perfect for eliminating moisture from the boat cabin and compartments.

How long should you let your boat dry before going to another lake?

Exercise all possible diligence to inspect and clean such boats. Boats leaving a water body known to be infected: After inspection and cleaning according to these procedures, allow the boat and trailer to air-dry for at least 7 days. 3 Longer is better.