A blog about boats, fishing, water sports and having fun on the ocean
How do you set up a beginner fishing pole?
by
Start with an arm’s length of 30- to 50-pound monofilament fishing line as a leader. Tie four 2- to 3-inch dropper loop knots 3 to 4 inches apart. Attach a sinker to the bottom loop using one of your fishing knots. Tie a hook to each of the two middle loops.
The five basic methods of angling are bait fishing, fly-fishing, bait casting, spinning, and trolling. All are used in both freshwater and saltwater angling. Bait fishing, also called still fishing or bottom fishing, is certainly the oldest and most universally used method.
It doesn’t seem far, but go measure it out. Most anglers proficient at casting average 25-30 yards, depending on their tackle and wind conditions.
How do you set up a beginner fishing pole? – Related Questions
How do you cast a fishing pole accurately?
How do you cast a casting rod?
How do you cast and reel a fishing pole?
How do you tie a fishing line step by step?
More videos on YouTube
Step 1: Start by folding over your fishing line to make a loop. Thread the loop through the hook’s eye.
Step 2: Make an overhand knot with slack.
Step 3: Move the loop portion around the end of the fish hook.
Step 4: Pull and tighten the line to fasten the knot.
Where should I put the weight on my fishing line?
Should I tie my lure directly to my line?
Whats the strongest knot for fishing?
The Palomar Knot is the strongest fishing knot in many situations. This knot only has 3 steps making it extremely powerful and very basic. Since there are not many twist and kinks in this knot it makes it extremely tough to break. It can be used on Braided line and Mono-filament.
How do you properly fish?
How to Fish: Fishing Tips for Beginners
Match your lure to the water color.
Choose your lure shapes and sizes that let you “match the hatch.”
Get fishing gear that appropriately size to the fish you’re pursuing.
If you are trolling, make sure your lures are swimming in a lifelike manner.
Choose your fishing line wisely.
What is the weakest knot?
The clove hitch is the weakest of the common climbing knots, at 60 to 65 percent. Note, however, that modern climbing ropes have a tensile strength of upwards of 6,000 pounds, so even a clove hitch would fail at something like 3,600 pounds.
A simple overhand knot weakens line by about 50 percent. Practice tying knots. Take a length of fishing line, a hook with the point cut off or buried into a cork, and practice. Practice until you can tie each knot correctly.
Why do fish keep snapping my line?
Too many anglers attach the lure to the rod before storing, then crank the reel so it’s really tight. When it’s too tight, the eyelet will be putting a lot of pressure on a groove in the line and over a long period of time in storage, this will create a weak spot in the line, leaving it vulnerable to snapping.
Why does my line keep snapping when I cast?
(1) Your braided fishing line may be too light; (2) Your line might be digging in against itself on the spool; (3) There could be an issue with your line guides or other equipment; (4) Your knot might be weak; (5) Your line may be nicked from fish or abrasions; or (6) You might be overpowering your casts.
Should fishing line be tight?
It should take a fair amount of pressure to make the line come out. If you catch a small fish and it takes the drag out, tighten it. If a big fish starts to pull real hard and you think the line is going to break, loosen the drag. Simple as that.
Should you wet your fishing line before spooling?
Warm Water
Always prior to spooling up with mono, leave your line submerged in a bucket of warm water. This will allow the water to soak into the line helping not only when you come to wind the line on but also allowing the line to bed down property on your spool.
Attach the sinker about 2 ft (0.61 m) above the hook.
Leaving space between the sinker and hook helps your bait float up so it’s more visible to fish. Measure up from the top of your hook and pinch the line so you don’t lose your place. Positioning your sinker much higher on your line may make it difficult to cast.
Why do you soak fishing line before spooling?
1 Begin by soaking the bulk spool in a bucket of warm (not hot) water. This will make the line suppler and remove some of the storage memory. It will also mean you can add some tension to the line with your finger and thumb when spooling-up without burning your skin via the friction heat.